# SMA 1501: Reconnection fault grid

**Series:** SMA Sunny Tripower 3.0 / 4.0 / 5.0 / 6.0 (STPxx-3AV-40)

**Meaning:** The changed country standard, or the value of a parameter that was set, does not correspond to the local requirements, so the inverter cannot connect to the utility grid. SMA's remedy is to select the parameter 'Set country standard' and check its value.

## Likely causes
- Country standard not matching the site's grid code
- A grid parameter set outside the local requirements

## Checks
- Select the parameter Set country standard and check its value
- Correct the country standard to match the local grid requirements
- Re-commission and confirm the inverter connects to the grid

## Parts implicated
grid connection

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 88 — "Explanation: The changed country standard or the value of a parameter you have set does not correspond to the local requirements. The inverter cannot connect to the utility grid." — https://files.sma.de/downloads/STP3-6-3AV-40-BE-en-22.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: no
