# SMA 7002: Fault sensor interior temperature

**Series:** SMA Sunny Tripower 3.0 / 4.0 / 5.0 / 6.0 (STPxx-3AV-40)

**Meaning:** Events 7001 and 7002 report 'Fault sensor interior temperature': a temperature sensor inside the inverter is defective, the inverter interrupts feed-in operation, and the cause must be determined by the Service. SMA's only measure is to contact Service.

## Likely causes
- Internal temperature sensor failed or disconnected
- Sensor harness or measurement circuit fault on the control board

## Checks
- Note the event number and the inverter serial number
- Contact SMA Service; do not open the inverter to reseat the sensor

## Parts implicated
temperature sensor

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: none

## Provenance
- [manual] p. 96 — "Explanation: A temperature sensor in the inverter is defective and the inverter interrupts the feed-in operation. The cause must be determined by the Service." — https://files.sma.de/downloads/STP3-6-3AV-40-BE-en-22.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
