# SMA 9101: AC voltage calibration failed

**Series:** SMA Sunny Tripower 3.0 / 4.0 / 5.0 / 6.0 (STPxx-3AV-40)

**Meaning:** An error occurred while the inverter was calibrating its AC voltage measurement, so its grid-voltage readings cannot be trusted. SMA states that the cause must be determined by the Service and gives no field repair.

## Likely causes
- AC voltage measurement or calibration circuit fault
- Control-board fault inside the inverter

## Checks
- Note the event number and the inverter serial number
- Contact SMA Service; do not attempt a field repair

## Parts implicated
inverter, AC measurement

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 100 — "Explanation: An error has occurred during calibration. The cause must be determined by the Service." — https://files.sma.de/downloads/STP3-6-3AV-40-BE-en-22.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
