# SolarEdge 18x76: Temperature too low

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter is too cold to operate. The addendum says to make sure the inverter is installed in a location with ambient temperatures within the range specified in the datasheet.

## Likely causes
- Ambient temperature below the inverter's operating range
- Inverter mounted in an exposed or unheated location

## Checks
- Measure the ambient temperature at the inverter
- Compare the site temperature range with the datasheet operating range
- Relocate or shelter the inverter if the site is outside the range

## Parts implicated
none

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: none

## Provenance
- [manual] p. 4 — "Temperature Too Low Make sure the inverter is installed in a location with ambient temperatures within the range specified in the datasheet." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
