# SolarEdge 2x18: Faulty temperature sensor

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter reports a faulty temperature sensor: the addendum describes it as a broken or unconnected temperature sensor and directs you to contact SolarEdge Support.

## Likely causes
- Temperature sensor disconnected or broken
- Sensor harness damaged

## Checks
- Note the code and contact SolarEdge Support
- Do not open the inverter to reseat the sensor yourself

## Parts implicated
temperature sensor

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: pv_dc

## Provenance
- [manual] p. 3 — "Faulty Temp. Sensor Broken or unconnected temperature sensor. Contact SolarEdge Support." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
