# SolarEdge 2x20: AC voltage too low

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The AC grid voltage the inverter measures is below the limit for the selected country. The addendum's remedy is to verify that the inverter is set to the correct country, then to consult the grid operator.

## Likely causes
- Grid under-voltage or a weak grid connection
- Inverter set to the wrong country/grid code
- Undersized or damaged AC cable causing voltage drop

## Checks
- Verify that the inverter is set to the correct country
- Consult the grid operator about the supply voltage
- Check the AC cable size and terminations against the installation guide

## Parts implicated
AC wiring

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 3 — "AC Voltage Too Low Verify that the inverter is set to the correct country." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
