# SolarEdge 2x22: AC frequency too high (line 1/2/3)

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter measured an AC grid frequency above the upper limit of the selected country grid code, so it disconnected from the grid. The addendum lists the message without a field repair; the cause is on the grid side or in the country setting.

## Likely causes
- Grid frequency excursion above the country limit
- Inverter set to the wrong country/grid code
- Local generator or backup source holding the frequency high

## Checks
- Confirm the country/grid-code setting in SetApp
- Ask the grid operator whether a frequency excursion was recorded
- Check that no local generator is back-feeding the site

## Parts implicated
AC wiring

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 3 — "AC Freq Too High (Line 1/2/3)" — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
