# SolarEdge 2x23: AC frequency too low (line 1/2/3)

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter measured an AC grid frequency below the lower limit of the selected country grid code and disconnected. The addendum lists the message without a field repair; investigate the grid supply and the country setting.

## Likely causes
- Grid frequency excursion below the country limit
- Wrong country/grid-code setting
- Weak or islanded grid supply

## Checks
- Confirm the country/grid-code setting
- Consult the grid operator about the frequency event
- Check for a local generator or islanding condition

## Parts implicated
AC wiring

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: dc_arc, grid_tie

## Provenance
- [manual] p. 3 — "AC Freq Too Low (Line 1/2/3)" — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
