# SolarEdge 2x24: DC injection (line 1/2/3)

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter detected DC current injected into the AC output on one of the lines, which indicates a problem in the inverter's output stage. The addendum has no field remedy and directs you to contact SolarEdge support.

## Likely causes
- Output-stage (H-bridge) fault in the inverter
- Current-sensor or control-loop fault

## Checks
- Note the code and serial number
- Contact SolarEdge support; do not keep the inverter connected to the grid

## Parts implicated
inverter

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie, pv_dc

## Provenance
- [manual] p. 3 — "DC Injection (Line 1/2/3) Contact SolarEdge support." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
