# SolarEdge 2x2C: No country selected

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** No country/grid code has been selected in the inverter, so it cannot apply the correct grid limits. The addendum says to select the country as described in the Country and Grid section of the installation guide.

## Likely causes
- Country not set during commissioning
- Firmware update or board replacement cleared the setting

## Checks
- Select the country in SetApp as described in the installation guide's Country and Grid section
- Re-commission the inverter and confirm it connects

## Parts implicated
none

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 4 — "No Country Selected Select the country, as described in the Country and Grid section of the installation guide." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: no
