# SolarEdge 2x9: AC current surge

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter logged a surge on the AC current input, shown together with a Vac surge. The addendum says a ground current surge can be involved and tells you to check the AC connection to the inverter and to ask the grid operator about large surge sources or irregular loads near the site.

## Likely causes
- AC voltage/current surge on the grid
- Irregular load or large surge source near the site
- Loose or damaged AC connection

## Checks
- Check the AC connection to the inverter
- Ask the grid operator whether a large surge source or irregular load exists near the site
- If the grid is clean, contact SolarEdge Support

## Parts implicated
AC wiring

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 1 — "AC Current Surge Vac surge Ground current surge." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
