# SolarEdge 2x98: Arc detector self-test failed

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter's arc-fault detector failed its own self-test. This is a self-test/hardware failure rather than a detected arc, and the addendum lists no field remedy.

## Likely causes
- Arc-detection circuit fault inside the inverter
- Firmware or detector self-test failure

## Checks
- Note the code and serial number
- Contact SolarEdge support; the arc protection must not be bypassed

## Parts implicated
inverter

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: dc_arc

## Provenance
- [manual] p. 5 — "Arc detector self-test failed" — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
