# SolarEdge 2xE: AC voltage too high (line 1/2/3)

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** An AC voltage surge drove the grid voltage above the permitted level, so the inverter tripped. The addendum advises checking the AC connection, confirming the country setting, checking with the grid operator and using a larger gauge AC wire where the inverter is far from the grid connection point.

## Likely causes
- Grid over-voltage or voltage surge
- Inverter set to the wrong country/grid code
- Voltage rise on a long, undersized AC run

## Checks
- Check the AC connection to the inverter
- Verify the inverter is set to the correct country
- Check with the grid operator for surge sources or irregular loads near the site
- Use a larger gauge wire for the AC output if the run is long

## Parts implicated
AC wiring

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 2 — "AC Voltage Too High (Line 1/2/3) AC voltage surge." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
