# SolarEdge 3x11: Arc fault detected

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter's arc-fault detector tripped: a DC arc was detected in the PV array. SolarEdge refers the installer to its arc-fault detection application note for the inspection and repair procedure.

## Likely causes
- Series or parallel DC arc in a string connector or cable
- Damaged module junction box or optimizer lead
- Loose DC connector under load

## Checks
- Follow the arc-fault detection application note before re-energising
- Inspect string connectors, optimizer leads and module junction boxes for arcing
- Repair or replace the damaged DC component; do not reset repeatedly

## Parts implicated
DC connectors, power optimizers, PV modules

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: dc_arc, pv_dc

## Provenance
- [manual] p. 5 — "Arc Fault Detected Refer to http://www.solaredge.com/sites/default/files/arc_ fault_detection_application_note.pdf" — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
