# SolarEdge 3x2: Software (SW) error

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter's firmware reported an internal software error. SolarEdge's troubleshooting addendum gives no field repair for SW Error codes and directs the installer to contact SolarEdge Support with the code.

## Likely causes
- Internal firmware or software fault
- Control-board fault

## Checks
- Record the exact code shown on the LCD/SetApp status screen and the inverter serial number
- Contact SolarEdge Support with the code and serial number; do not attempt a field repair

## Parts implicated
control board

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: pv_dc

## Provenance
- [manual] p. 1 — "SW Error Contact SolarEdge Support." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: no
