# SolarEdge 8x2D: Grid sync error

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The inverter could not synchronise to the grid. The addendum says to check grid voltage and frequency stability.

## Likely causes
- Unstable grid voltage or frequency
- Loose AC connection or high impedance on the AC run

## Checks
- Check grid voltage and frequency stability at the connection point
- Check the AC terminations and cable size
- Consult the grid operator if the supply is unstable

## Parts implicated
AC wiring

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie

## Provenance
- [manual] p. 4 — "Grid Sync Error Check grid voltage and frequency stability." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
