# SolarEdge 8x34: DC voltage too high (surge, three-phase)

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** A three-phase inverter saw a DC input over-voltage (codes 8x34/8x35/8x37), normally a surge that the SolarEdge system should clear. If it persists, isolate, wait five minutes and locate the malfunctioning string.

## Likely causes
- PV string too long for the DC input range
- Power optimizer failure
- DC surge or loose string connection

## Checks
- Switch the inverter OFF, wait five minutes and check the safety voltage
- Locate the malfunctioning string and recheck its connections
- Follow the Power Optimizer Troubleshooting section of the installation guide

## Parts implicated
PV strings, power optimizers

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: dc_arc, grid_tie, pv_dc

## Provenance
- [manual] p. 2 — "DC Voltage Too High (surge) The SolarEdge system normally eliminates DC overvoltage errors." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
