# SolarEdge 8x3A: AC over-current (line 1/2/3)

**Series:** SolarEdge single-phase and three-phase inverters (Europe & APAC)

**Meaning:** The AC output current exceeded the inverter's limit on one of the lines (codes 8x3A/8x3B/8x3C and 8x3F/8x40/8x41). The addendum has no field repair and directs you to contact SolarEdge support.

## Likely causes
- Output over-current or a fault in the output stage
- Current-sensor or control-loop fault

## Checks
- Note the code and serial number
- Contact SolarEdge support

## Parts implicated
inverter

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: grid_tie, pv_dc

## Provenance
- [manual] p. 4 — "AC Over Current Line 1/2/3 Contact SolarEdge support." — https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (retrieved 2026-11-21)

- Confidence: verified
- Verified by: manual
- Requires qualified installer: yes
