# Victron Err 2: Battery voltage too high

**Series:** Victron SmartSolar / BlueSolar MPPT charge controllers, Inverter RS / Multi RS, Orion Smart DC-DC

**Meaning:** The charger has stopped because the battery voltage is above the configured limit. The error auto-resets once the voltage drops.

## Likely causes
- Other charging equipment on the same battery raising the voltage
- A fault in the charge controller
- Battery system voltage (12/24/48 V) set lower than the actual battery

## Checks
- Check for other chargers or alternators on the same battery
- Verify the battery voltage setting matches the connected battery in VictronConnect

## Parts implicated
charge controller, battery

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: lithium_battery

## Provenance
- [vendor_kb] § Err 2 - Battery voltage too high — "This error will auto-reset after the battery voltage has dropped." — https://www.victronenergy.com/live/mppt-error-codes (retrieved 2026-11-21)

- Confidence: verified
- Verified by: vendor_kb
- Requires qualified installer: yes
