# Victron Err 35: PV over-power

**Series:** Victron SmartSolar / BlueSolar MPPT charge controllers, Inverter RS / Multi RS, Orion Smart DC-DC

**Meaning:** The internal DC voltage is too high (or, on older firmware, a known bug). Update firmware first; the error usually auto-resets.

## Likely causes
- Firmware older than v1.08 (MPPT RS / Inverter RS / Multi RS)
- Internal DC voltage too high

## Checks
- Update firmware to v1.08 or newer
- If it persists, isolate all power, wait 3 minutes, repower

## Parts implicated
firmware, charge controller

## Safety
Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. This page is a diagnostic reference, not step-by-step work instructions. Isolate and verify de-energised before any physical check, and escalate to a qualified installer/electrician for anything beyond reading the display or checking a connector on isolated equipment.

Safety flags: dc_arc, pv_dc

## Provenance
- [vendor_kb] § Err 35 - PV over-power — "Applies to the MPPT RS, Inverter RS and Multi RS products." — https://www.victronenergy.com/live/mppt-error-codes (retrieved 2026-11-21)

- Confidence: verified
- Verified by: vendor_kb
- Requires qualified installer: yes
