Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. Read the safety model.
SMA Sunny Tripower 3.0 / 4.0 / 5.0 / 6.0 (STPxx-3AV-40)

SMA 301: Grid incident - ten-minute average grid voltage exceeded

confidence: verifiedchecked 2026-11-21
Quick answerSMA 301 means The ten-minute average value of the grid voltage has left the permissible range because the grid voltage or grid impedance at the connection point is too high, so the inverter disconnects from the utility grid to maintain power quality. SMA's remedy is to verify the grid voltage during feed-in and to have the grid operator adjust the feed-in voltage or the monitored limits..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.

What it means

The ten-minute average value of the grid voltage has left the permissible range because the grid voltage or grid impedance at the connection point is too high, so the inverter disconnects from the utility grid to maintain power quality. SMA's remedy is to verify the grid voltage during feed-in and to have the grid operator adjust the feed-in voltage or the monitored limits.

Likely causes

  • Sustained grid over-voltage over the ten-minute averaging window
  • High grid impedance at the connection point

What to check

  1. During feed-in, check whether the grid voltage at the connection point is permanently within the permissible range
  2. If local grid conditions are the cause, ask the grid operator to adjust the feed-in voltage or the monitored operating limits
  3. If the voltage is in range and the message persists, contact SMA Service

Parts implicated

grid connection
Sources (verbatim):
  • https://files.sma.de/downloads/STP3-6-3AV-40-BE-en-22.pdf (manual, retrieved 2026-11-21) p. 84
    “Explanation: The ten-minute average value of the grid voltage is no longer within the permissible range. The grid voltage or grid impedance at the connection point is too high. The inverter disconnects from the utility grid to maintain power quality.”

Paraphrased; verify against the manual for your exact model and serial number.