SolarEdge single-phase and three-phase inverters (Europe & APAC)
SolarEdge 18x85: Temperature sensor fault
Quick answerSolarEdge 18x85 means The inverter's temperature sensor is broken or unconnected. The addendum directs you to contact SolarEdge Support..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.
What it means
The inverter's temperature sensor is broken or unconnected. The addendum directs you to contact SolarEdge Support.
Likely causes
- Temperature sensor disconnected or broken
- Sensor harness fault
What to check
- Note the code and serial number
- Contact SolarEdge support; do not open the inverter
Parts implicated
temperature sensor
Sources (verbatim):
- https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (manual, retrieved 2026-11-21) p. 6
“Temp Sensor fault Broken or unconnected temperature sensor. Contact SolarEdge Support.”
Paraphrased; verify against the manual for your exact model and serial number.