Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. Read the safety model.
SolarEdge single-phase and three-phase inverters (Europe & APAC)

SolarEdge 2x1C: RCD sensor error

confidence: verifiedchecked 2026-11-21
Quick answerSolarEdge 2x1C means The inverter's residual-current (RCD) sensor reported an error, so the ground-fault protection path cannot be trusted. The addendum prints the message with no field remedy; SolarEdge support handles it..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.

What it means

The inverter's residual-current (RCD) sensor reported an error, so the ground-fault protection path cannot be trusted. The addendum prints the message with no field remedy; SolarEdge support handles it.

Likely causes

  • RCD sensor or its measurement circuit failed
  • Sensor harness fault on the control board

What to check

  1. Note the code and serial number
  2. Contact SolarEdge support; do not bypass or disable RCD protection

Parts implicated

RCD sensor
Sources (verbatim):

Paraphrased; verify against the manual for your exact model and serial number.