SolarEdge single-phase and three-phase inverters (Europe & APAC)
SolarEdge 2x2C: No country selected
Quick answerSolarEdge 2x2C means No country/grid code has been selected in the inverter, so it cannot apply the correct grid limits. The addendum says to select the country as described in the Country and Grid section of the installation guide..
Escalation. If the fix goes beyond a non-invasive check or a software setting, or you are not sure the system is isolated, stop and call a qualified installer.
What it means
No country/grid code has been selected in the inverter, so it cannot apply the correct grid limits. The addendum says to select the country as described in the Country and Grid section of the installation guide.
Likely causes
- Country not set during commissioning
- Firmware update or board replacement cleared the setting
What to check
- Select the country in SetApp as described in the installation guide's Country and Grid section
- Re-commission the inverter and confirm it connects
Parts implicated
None listed
Sources (verbatim):
- https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (manual, retrieved 2026-11-21) p. 4
“No Country Selected Select the country, as described in the Country and Grid section of the installation guide.”
Paraphrased; verify against the manual for your exact model and serial number.