SolarEdge single-phase and three-phase inverters (Europe & APAC)
SolarEdge 2x86: DSP1-DSP2 VDC difference max
Quick answerSolarEdge 2x86 means The two DSP controllers inside the inverter measured a DC voltage difference beyond the allowed maximum, which points to a hardware or sensing fault. The addendum directs you to contact SolarEdge support..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.
What it means
The two DSP controllers inside the inverter measured a DC voltage difference beyond the allowed maximum, which points to a hardware or sensing fault. The addendum directs you to contact SolarEdge support.
Likely causes
- DC voltage sensing or divider fault
- Power-board or DSP hardware fault
What to check
- Note the code and serial number
- Contact SolarEdge support
Parts implicated
inverterDC bus
Sources (verbatim):
- https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (manual, retrieved 2026-11-21) p. 7
“DSP1- DSP2 VDC difference max Contact SolarEdge support.”
Paraphrased; verify against the manual for your exact model and serial number.