Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. Read the safety model.
SolarEdge single-phase and three-phase inverters (Europe & APAC)

SolarEdge 2x98: Arc detector self-test failed

confidence: verifiedchecked 2026-11-21
Quick answerSolarEdge 2x98 means The inverter's arc-fault detector failed its own self-test. This is a self-test/hardware failure rather than a detected arc, and the addendum lists no field remedy..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.

What it means

The inverter's arc-fault detector failed its own self-test. This is a self-test/hardware failure rather than a detected arc, and the addendum lists no field remedy.

Likely causes

  • Arc-detection circuit fault inside the inverter
  • Firmware or detector self-test failure

What to check

  1. Note the code and serial number
  2. Contact SolarEdge support; the arc protection must not be bypassed

Parts implicated

inverter
Sources (verbatim):

Paraphrased; verify against the manual for your exact model and serial number.