Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. Read the safety model.
SolarEdge single-phase and three-phase inverters (Europe & APAC)

SolarEdge 2xE: AC voltage too high (line 1/2/3)

confidence: verifiedchecked 2026-11-21
Quick answerSolarEdge 2xE means An AC voltage surge drove the grid voltage above the permitted level, so the inverter tripped. The addendum advises checking the AC connection, confirming the country setting, checking with the grid operator and using a larger gauge AC wire where the inverter is far from the grid connection point..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.

What it means

An AC voltage surge drove the grid voltage above the permitted level, so the inverter tripped. The addendum advises checking the AC connection, confirming the country setting, checking with the grid operator and using a larger gauge AC wire where the inverter is far from the grid connection point.

Likely causes

  • Grid over-voltage or voltage surge
  • Inverter set to the wrong country/grid code
  • Voltage rise on a long, undersized AC run

What to check

  1. Check the AC connection to the inverter
  2. Verify the inverter is set to the correct country
  3. Check with the grid operator for surge sources or irregular loads near the site
  4. Use a larger gauge wire for the AC output if the run is long

Parts implicated

AC wiring
Sources (verbatim):

Paraphrased; verify against the manual for your exact model and serial number.