SolarEdge single-phase and three-phase inverters (Europe & APAC)
SolarEdge 2xF: DC voltage too high (surge)
Quick answerSolarEdge 2xF means The DC input voltage from the PV array exceeded the inverter's limit, usually as a surge. SolarEdge notes its system normally eliminates DC over-voltage errors; if the fault persists, switch the inverter off, wait five minutes and check which string is malfunctioning and its connections..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.
What it means
The DC input voltage from the PV array exceeded the inverter's limit, usually as a surge. SolarEdge notes its system normally eliminates DC over-voltage errors; if the fault persists, switch the inverter off, wait five minutes and check which string is malfunctioning and its connections.
Likely causes
- PV string too long for the inverter's DC input range
- Power optimizer failure or bypassed optimizer
- DC surge or loose string connection
What to check
- Turn the inverter ON/OFF switch OFF and wait five minutes
- Check whether the LCD shows the expected low safety voltage (about 1 V per optimizer)
- Identify the malfunctioning string and recheck its connections to the inverter
- Follow the Power Optimizer Troubleshooting section of the installation guide
Parts implicated
PV stringspower optimizersDC cabling
Sources (verbatim):
- https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (manual, retrieved 2026-11-21) p. 2
“DC Voltage Too High (surge) The SolarEdge system normally eliminates DC overvoltage errors.”
Paraphrased; verify against the manual for your exact model and serial number.