SolarEdge single-phase and three-phase inverters (Europe & APAC)
SolarEdge 3x2: Software (SW) error
Quick answerSolarEdge 3x2 means The inverter's firmware reported an internal software error. SolarEdge's troubleshooting addendum gives no field repair for SW Error codes and directs the installer to contact SolarEdge Support with the code..
Escalation. If the fix goes beyond a non-invasive check or a software setting, or you are not sure the system is isolated, stop and call a qualified installer.
What it means
The inverter's firmware reported an internal software error. SolarEdge's troubleshooting addendum gives no field repair for SW Error codes and directs the installer to contact SolarEdge Support with the code.
Likely causes
- Internal firmware or software fault
- Control-board fault
What to check
- Record the exact code shown on the LCD/SetApp status screen and the inverter serial number
- Contact SolarEdge Support with the code and serial number; do not attempt a field repair
Parts implicated
control board
Sources (verbatim):
- https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (manual, retrieved 2026-11-21) p. 1
“SW Error Contact SolarEdge Support.”
Paraphrased; verify against the manual for your exact model and serial number.