SolarEdge single-phase and three-phase inverters (Europe & APAC)
SolarEdge 8x51: RCD current surge
Quick answerSolarEdge 8x51 means A residual-current surge was detected on the DC side, which usually means a ground-fault/insulation problem in the PV array. SolarEdge points to its isolation-fault troubleshooting application note and to support..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.
What it means
A residual-current surge was detected on the DC side, which usually means a ground-fault/insulation problem in the PV array. SolarEdge points to its isolation-fault troubleshooting application note and to support.
Likely causes
- Insufficient insulation to ground in the PV array
- Damaged DC cable or connector
- Water ingress in a junction or optimizer
What to check
- Follow the isolation-fault troubleshooting application note
- Isolate and test string by string to locate the leakage
- Contact SolarEdge support if the fault persists
Parts implicated
PV modulesDC cablingRCD
Sources (verbatim):
- https://web.archive.org/web/20230202122919/https://knowledge-center.solaredge.com/sites/kc/files/se-inverter-installation-guide-error-codes.pdf (manual, retrieved 2026-11-21) p. 4
“RCD Current Surge Refer to: www.solaredge.com/files/pdfs/application_note_ isolation_fault_troubleshooting.pdf Contact SolarEdge support.”
Paraphrased; verify against the manual for your exact model and serial number.