Victron SmartSolar / BlueSolar MPPT charge controllers, Inverter RS / Multi RS, Orion Smart DC-DC
Victron Err 18: Controller over-current
Quick answerVictron Err 18 means Current on the battery terminals exceeded the controller limit. It usually auto-resets; if not, the unit can be power-cycled..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.
What it means
Current on the battery terminals exceeded the controller limit. It usually auto-resets; if not, the unit can be power-cycled.
Likely causes
- Large load switched on the battery side
- Sudden irradiance change causing a temporary power spike
- Inverter AC output overloaded
What to check
- Allow the controller to cool and provide adequate ventilation
- Reduce inverter load
- If it persists, isolate all power, wait 3 minutes, then repower
Parts implicated
charge controller
Sources (verbatim):
- https://www.victronenergy.com/live/mppt-error-codes (vendor_kb, retrieved 2026-11-21) § Err 18 - Controller over-current
“This error will auto-reset.”
Paraphrased; verify against the manual for your exact model and serial number.