Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. Read the safety model.
Victron SmartSolar / BlueSolar MPPT charge controllers, Inverter RS / Multi RS, Orion Smart DC-DC

Victron Err 2: Battery voltage too high

confidence: verifiedchecked 2026-11-21
Quick answerVictron Err 2 means The charger has stopped because the battery voltage is above the configured limit. The error auto-resets once the voltage drops..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.

What it means

The charger has stopped because the battery voltage is above the configured limit. The error auto-resets once the voltage drops.

Likely causes

  • Other charging equipment on the same battery raising the voltage
  • A fault in the charge controller
  • Battery system voltage (12/24/48 V) set lower than the actual battery

What to check

  1. Check for other chargers or alternators on the same battery
  2. Verify the battery voltage setting matches the connected battery in VictronConnect

Parts implicated

charge controllerbattery
Sources (verbatim):

Paraphrased; verify against the manual for your exact model and serial number.