Qualified installer only. High-voltage, grid-tied and battery systems can kill. Do not open energised DC/AC equipment. Read the safety model.
Victron MultiPlus / Quattro / MultiPlus-II / EasySolar-II (VE.Bus inverter/charger)

Victron VE.Bus Error 24: Switch-over system protection initiated

confidence: verifiedchecked 2026-11-21
Quick answerVictron VE.Bus Error 24 means Current was detected flowing through the back-feed relay while it should be open, so the system stopped switching to grid/generator..
Qualified installer only. This fault touches the AC grid connection, battery bank, DC bus, or an internal power stage. Isolate and verify de-energised, then escalate to a qualified installer/electrician.

What it means

Current was detected flowing through the back-feed relay while it should be open, so the system stopped switching to grid/generator.

Likely causes

  • External current sensor connected but option not checked in VEConfigure
  • Too much AC load at switch-over preventing relay opening
  • Generator AC voltage dropping slowly before rejection
  • Faulty back-feed relay or current measurement circuit

What to check

  1. Check 'External current sensor connected' in VEConfigure if an external sensor is used
  2. Remove excessive load at switch-over
  3. Raise the lower AC input voltage limit (e.g. 210 VAC) for generators
  4. Replace faulty unit if a relay/measurement fault is confirmed

Parts implicated

back-feed relayAC loads
Sources (verbatim):
  • https://www.victronenergy.com/live/ve.bus:ve.bus_error_codes (vendor_kb, retrieved 2026-11-21) § Error 24 - Switch-over system protection initiated
    “This error indicates that one or more units report feeding back a significant current through its back-feed relay, while those relay are supposed to be open, and -obviously- no current can flow through an open circuit.”

Paraphrased; verify against the manual for your exact model and serial number.